Enter subtitle here
Laminated Counter Top Installation Tips
Here i will discuss a small collection of suggestions as well as tips on how to install counter tops created from plastic laminate. These types of ideas are designed to safe period, effort and money throughout the project.
The following suggestions are recommended for planning a surface for the installing laminated plastic:
o Your projects surface should be flat, since laminated plastic sheets had been created to be used on toned surfaces only. If you have laminated plastic at a 1/32" width, you can use them on up and down surfaces but the 1/16" linens should be left for smooth surfaces like counters along with flooring.
o Make sure that you clean up, and thoroughly sand the area that will be below the plastic layered. If there is any paint or even varnish on the surface before set up, remove that too.
to Regular particle board and often plywood are the best bases with regard to plastic laminates, so steer clear of the high-density particle board buzz.
The following tips are recommended regarding cutting the laminated plastic material before installation:
o You may use a circular saw to perform the job, or a backsaw or perhaps utility knife instead. Ensure that the blade that you utilize when sawing is fine-toothed, and place a strip associated with masking tape down to plan to cut, to prevent breaking as well as making the line a good deal easier to see.
o If you are using a saber or energy circular saw, begin reducing on the backside of the layered because these saws tend to reduce on the upstroke, so it stop chipping. If you are using a hands saw, cut from the top side, but at a lower angle.
o You can also make use of a fine-toothed hand saw whenever cutting laminated plastics.
a Make sure that you have chosen the right cutting tool for the scale the job that requires it.